Hot aluminum rod peeling machine

Structure characteristics of hot aluminum rod peeling machine：
Adopting four-tensioned column frame structure to increase structural strength and reduce its elastic deformation when subjected to torsion.

The bar-holding device adopts the rail lifting and positioning method, which reliably ensures smooth lifting and accurate positioning.

The aluminum skin feeding device adopts the rotating hopper method, which can reliably take up the broken skin and disconnected loose skin generated during the peeling process as well as the final complete aluminum skin.

Thickness of hot peeling (mm): 2~4 on one side; i.e. cold aluminum bar outer diameter φ302±0.7 after peeling (aluminum bar size error before peeling is thrown away)

Peeling speed (mm / s): 40 ~ 80

Peeling temperature (℃) with the extrusion temperature and ≥ 420

Finished product surface finish not less than 12.5μm

Roundness of finished product: ≤0.3%

Straightness of finished product: ≤0.2%

Electrical control: Japan Mitsubishi PLC centralized control; electrical components using Schneider products.

Degree of automation: linkage with the hot heating furnace, press a button to complete the supply of rods, peeling, rods, as well as the collection of waste skin and all other actions; if the customer requires interconnection with the extrusion machine; can also be manually operated;.

1, Mainly used for removing the oxide layer of aluminum bar before extrusion processing.

2, compared to the traditional turning peeling can improve the processing efficiency by several times.

3, the scrap recovery rate can be increased by 20-30% because the peeled skin is more complete.

4, The skin thickness can be 1-4mm according to the customer's requirements, and the surface finish can reach R6.3.